C&N PETROLEUM EQUIPMENT

SJF Swivel Joints provide 360°rotational movement of loading arm components.

Stainless Steel construction and available in 75 mm (3”) and 100 mm (4”) sizes with 100mm TTMA flanges on each end.

This swivel incorporates the well known high load, low wear Liquip principle of ball and needle bearing combination used in Liquip’s extensive range of loading arms.

Sealing is enhanced by the purpose designed, Viton primary face seal, and two Viton o-rings which isolate the bearing pack from product leaks.

If the primary seal is compromised any contamination will be contained by an o-ring before damage to the bearings can occur.

Any leak is also immediately visible from a telltale weep indicator hole, supplied with plug fitted.

The greasing system also includes the Liquip trade-mark of a pressure relief outlet to ensure correct lubrication, by ejecting old grease and particles that can cause wear.

ADJUSTMENT OR SERVICE

Re-grease at maximum six-month intervals dependent on service conditions.

MATERIALS OF CONSTRUCTION

Bodies – Cast Stainless steel

Seals - Viton or Teflon

TECHNICAL DATA

Working pressure –900 kPa

Test pressure – 1500 kPa

WEIGHT

SJF076 / SJF076L – 8.3 Kg.

SJF101/ SJF101L – 8.99 Kg.

MOUNTING
Using M10 diameter bolts or studs. For high load applications high tensile bolts or studs must be used.

If the unit is mounted vertically, the female component must be fitted on top to prevent water and dust ingress.

PART NUMBERS

• SJF076 - 304 Grade Stainless Steel, Viton Seals, 75mm
• SJF076L - 316L Grade Stainless Steel, Viton Seals, 75mm
• SJF101 - 304 Grade Stainless Steel, Viton Seals, 100mm
• SJF101L - 316L Grade Stainless Steel, Viton Seals, 100mm
• SJF101T - 304 Grade Stainless Steel, Teflon Seals, 100mm

2008 C&N PETROLEUM EQUIPMENT

Design: DRAGAN GRAFIX